Cracks on your driveway can overshadow the appeal of your home. Driveway sealing is considered not only to retain that brand new look but also to prevent damage during extreme weather especially on the winter months. If you are considering sealing driveways cracks, you may hire a specialist to offer the service or do it on your own. Making it a DIY project is obviously a cheaper alternative but coating specialists are likely to save you time and money on driveway sealing.
So what is the cost of driveway sealing? When you want to estimate the entire cost of this project, the one thing you have to consider is the square footage of your driveway. Driveway sealing will cost $150 to $180 per square feet. If you want to calculate the square footage, start by measuring the length and width of your driveway. Multiply these two numbers to get the square footage. This will help you to calculate the sealing cost.
The other thing that will affect your cost is the price of the sealant. This will depend on the type of sealer used that is properly suited for your driveway. For asphalt driveways, the cheapest sealers are tar emulsion sealers. They cost approximately $12 per 5 gallon. This type of sealer will need thorough stirring before the application process begins.
You can also consider sealing driveways cracks using the asphalt emulsion sealers, which have an average cost of $25 per 5 gallon pail. The good thing about these sealers is that they prevent oil stains and penetration and do not require constant stirring throughout the application. The most expensive sealers are the advanced latex acrylic sealers, which cost $60 per 2 gallon pail on average. This is due to the fact that they have a longer lifespan, dry very quickly and fade less. If you are looking for some superior surface protection then be ready to invest a handsome amount on the liquid rubber sealers, which are made with titanium. They cost above $500 per 5 gallon pail.
Next, consider this, is your driveway right for sealing? Most driveways made of concrete or asphalt can be seal coated but the same cannot be done on a dirt and gravel driveway. The other thing that will determine whether the driveway qualifies for seal coating is the duration in which it has been around. For instance, if you have an asphalt driveway, you have to give it 6 months after installation before you consider any form of seal coating.
Driveways need to be properly prepared before sealing. You can start by removing any greasy or oily stains with hot soapy water or a commercial degreaser. The cracks also need to be cleaned before sealing. You can use a wet or dry vacuum to do this. Pick out any debris, weeds or grass that has been trapped inside the cracks before sealing. You can sweep the entire driveway and then remove dust and dirt using the pressure water. Just ensure that it is thoroughly clean before sealing.
Before you begin sealing driveways cracks, make sure the driveway is completely dry. Remember that sealers come with different application instructions. You can start by pouring the sealant across the driveway. Use a squeegee to spread it along the width of the driveway until you have covered the entire section. Make sure the coat is thin for proper results. If you have excess sealant on some areas, use the edge of a bristle brush to spread it. After making this first application, allow it to settle for about 6 to 12 hours before you apply the second coat. Once you are through, block the entrance to the driveway to prevent any traffic.